RPI Zero W2 - FLIRC Case - Piggy back mount for Prusa i3 mk3s
Description
This "Piggy back" mount allows you to attach a Pi Zero w2 enclosed in a Flirc aluminium case directly on to your Prusa mk3s+ Einsy cover. The Pi is connected to the Einsy board with 4 wires (+5, 0, Tx, Rx). The only pheripherals I use with the Pi is a low powered webcam and the 5V regulator on Einsy seems to be able to handle it well. I do not take responsibility if your setup would destroy your Einsy. The mount attaches to the Stock Einsy cover with four zipties. Remember to shut down your RPI from Octoprint before turning off your Prusa. Enjoy! Other components for installation: 4 x M3x6mm or similar screws. 4 x Zipties 1 x connecting cable (4 lead dupont female to female) 1 x right angle pin header spacing 2.54mm/0.1'' protruding min. 11.5mm. (I made one from the longest pins in a 3-row right angle 2.54mm PCB connector/pin header).
Statistics
Likes
0
Downloads
0