Bosch GST 8000 E jigsaw dust extractor
Description
Dust extractor for my GST 8000 E jigsaw. Since the original dedicated suction area is too narrow, I added suction channels on both sides. You'll notice that STLs differ from the photos a bit. Middle suction part needed some filing therefore I shaved a skinny surface around it.Additionally I opened a circular area for the mating surface for extension.Hopefully it would be easier for you now. It may still be a tight fit so be careful. Inner diameter of the extension part(for suction side) is 33mm. You should close the front part of the jigsaw with a transparent plastic, I cut a part from a lid of a yogurt cup. I used a 0.6mm nozzle on Ender 3 v2. With 0.48 layer height, main part took 3.5hrs. No need for supports.
Statistics
Likes
0
Downloads
0