Sidewinder x2 Z Support
Description
Support for the Sidewinder x2 to help reduce z wobble. I wanted a simple, print only Z-axis support for the Sidewinder x2. Since it is fairly new, all the supports are for the x1. This allows you to screw the support to the wall at an optimal distance to allow for the y-axis cable. The support attaches to the printer via the slots for the spool holder. You will need some kind of set screw the same size as the one on the spool holder to tighten it to the printer. Please measure the distance between your spool slot on the printer and your wall. In your slicer, turn off uniform scaling, and adjust the LENGTH ONLY to the length you need. Edit: I have tested this and can confirm that the tab fits into the filament spool slot. The length is plenty long enough to keep the bed away from the wall. It is set at the ideal length to minimize waste of space while still allowing a full range of motion from the printer. I may add a minimalized version soon if requested, so that it uses much less filament and takes less time.
Statistics
Likes
3
Downloads
0