Simple BL-Touch mount vor VORON Afterburner (on Ender 3)
Description
This is a very simple mount to click in a BL-Touch and fit it to a Voron-afterburner (I tested it only on an Ender 3 Switchwire linear rails version). Just test fit it in terms of height, then mark two spots and mount two meltin-threadinsterts M3 to the x-carriage frame (presumeably on the right side if you look at it to match the other cables). Then screw the mount on and fineadjust the height according to your needs. I use a Micro-Suisse Hotend and I had to adjust the firmware for the offsets as follows: #define NOZZLE_TO_PROBE_OFFSET { +37, +26, -0.525} Z-offset ist for sure depending on your setup! Beware: it sits pretty tight on the neck of the BLtouch. I might come up with a better solution but this one quckly did the trick for me. OpenSCAD includes as always. Have fun!
Statistics
Likes
2
Downloads
0