SSUPD Meshlicious Panel Mount HDMI 48Gbps + DP Bracket
Description
*Updated from [original design](https://www.thingiverse.com/thing:4878018). -Added support for the sole 48 Gbps (4K @120, 8K @ 60) HDMI extender on amazon at the time. -Switched to vertical arrangement following the style of [n1klas's remix](https://www.thingiverse.com/thing:4896032) for easier grip of connectors. However I can't fit that many ports since I don't use the standoff mod. -Reduced corner radius of mounting bracket to better match the case.* I love the SSUPD Meshlicious PC case, but I wanted regular back panel display connectors instead of trying to plug in angled connectors through the bottom. This bracket clamps around the rear display cable hole and provides a surface for panel-mount connectors (DP, HDMI, etc). There is a little bit of flex when plugging/unplugging cables, but the panel stays firmly in place. Included STLs support the following panel-mount connectors and require the highest GPU position for clearance. Pictured port arrangement is for the MSI Ventus 3080 in the highest GPU position and without any standoff mods. [DP](https://www.amazon.com/gp/product/B07FFQGSNF) (Left angle variant) - Requires 5-8mm M3 screws, not included. Tested 1440p@144Hz with G-SYNC. [HDMI 48Gbps / 8K@60 / 4K@120](https://www.amazon.com/gp/product/B08MC6LJXG) (Right angle variant) - Tested 4K@120 HDR with G-SYNC. Mounted with 8mm M3 screws and an M3 hex nut. No panel mount versions were available, so a nut trap is included to glue on the sides of the female HDMI connector. [This set](https://www.amazon.com/gp/product/B06XQLTLHP) was used, but most M3 nuts should fit - or you can edit the step file to suit your needs. Mind the layer height, as the bracket thickness and nut traps are designed around 0.2mm on all layers. Included blank in STEP and STL for cutting your own mounting holes for other connectors. The two halves rely on the panel mount screws to clamp on the case.
Statistics
Likes
2
Downloads
0