CR10/Ender 3 Fanduct for Stock Setup with 40mm fans
Description
I designed this Fan Duct for any stock Creality CR10 or Ender3 setup, which is inspired by my Fan Duct for the MicroSwiss DirectDrive (https://www.thingiverse.com/thing:4886226) to increase the part cooling capabilities. . . It can be used with a full stock setup as well as the MicroSwiss AllMetalHotend. . . For easy installation and access to the hotend it consists of three parts: -The main part including the part cooling ducts and backplate -The removable front fan adapter -The removable cable guide for cable management . . It uses two 40mm Fans mounted to the sides for part cooling and another 40mm Fan mounted to the front adaptor for cooling the heatbreak/cooling block. All parts are connected with standard M3 screws. . . . V1 features: -BLTouch and 18mm probe mount on the front fan adapter (for EZABL,CR10S Probe,...) -removable cable guide for use with zip-ties -good ground clearance to avoid hitting bed clips,... -easily printable with supports set to "Touching Buildplate" in Cura . . I also included some photos for the X- and Y-offsets between the nozzle and BLTouch: . BLTouch: define NOZZLE_TO_PROBE_OFFSET {31.98 , -39.13} 18mm Probe: define NOZZLE_TO_PROBE_OFFSET {-32.69 , -45.05} . . If you decide to print the fan duct please consider posting your print as a make or if you did some changes/adjustments or added your own mounts for it, share it as a remix please, so that everybody can profit from it!
Statistics
Likes
2
Downloads
0