Ender 3 Switch Panel for Lack enclosure
Description
PRINT AT 103-106% SCALE! The sizing is very slightly off so print it larger...if the fit of the switch is too tight print it a couple percent larger. I did 103% and it fits but it's really tight. Fits the factory Ender 3 or Ender 3 Pro power switch and can be used to relocate it for a lack enclosure. Print in the orientation of STL with regular supports with 40% density, this will allow the switch to sit flush. It can be installed using #6 wood screws and then the wires can be extended from the factory location on the power supply. It's easier to put the screws in then the switch but it can be done either way. Also, the countersink is not even close to being the right depth but it's not visible from the front so I didn't worry about changing it. Personally, I printed it at 100% infill out of black PLA but any filament type would work fine so PETG and ABS are also good options just be sure to scale accordingly. (ABS probably 107-109% size)
Statistics
Likes
5
Downloads
0