Controller mounts for Nintendo Switch
Description
Model: https://www.prusaprinters.org/prints/93122-controller-mounts-for-nintendo-switch These are meant to be attached to a flat surface with double-sided tape. Works very reliably if tape is used according to it's manual (apply pressure, use vertical lines, etc.) That said, if yours fall and break, I will take no responsibility. (seems obvious but who knows?) I recommend using PETG because it is a little softer than ABS, which most of controllers are made of. I've had no signs of wear or scratches from these mounts on any of my controllers. This is not a remix, but pro controller mount is made to look similar to the mount for Xbox controller modeled by crazyg0od33. I've been using it for a while now and it is just perfect. Check it out if you also have an Xbox controller: https://www.thingiverse.com/thing:1176663 In case you didn't already know Metroid Dread is awesome LLAP
Statistics
Likes
0
Downloads
0