Quick Change Paper Towel Holder 2.0
Description
Here is an complete redesign of my original Quick Change Paper Towel Holder. This new design is less bulky and has a built-in tension bar to prevent you for unraveling the paper towel roll too far. You will need 2 rubber bands and 4 #10x1/2" Pan head screws to install. The Flippers snap onto the Arm brackets easily and the rollers are printed as one piece and will need to be snapped free of their supports. The Roller Bar and Arm brackets will need to be flipped in your slicer to create both the left and right side parts for the assembly. While not required, I also recommend adding a 100% infill to the tips of the flippers to help them fall into place more consistently. Installation tips: The Tension Bar has "V" shaped cutouts that line up with the inner screw holes of the Arm Brackets. The Arm Brackets are printed with a 90degree angle and could be used as a square in a pinch. Pre drill the screw holes and do not over tighten the screws or the print could be damaged. Refer the installation Guide for more detailed instructions I greatly appreciate any support. It took alot of hours to design and fine tune this project. I am currently printing and selling this project on my Etsy store.https://www.etsy.com/shop/MasicDesigns Please consider following or liking my Facebook Page as well https://www.facebook.com/masicmitch
Statistics
Likes
31
Downloads
0