Cable connector Wago 221-2411 with cable gland (M25 & M16)
Description
This file is available on wago-creators: https://wago-creators.com/design/176 <hr> Allows easy connection of up to 4-wire cables more conveniently and quickly via Wago 221-2411 lever terminal than with commercially available screw terminal variants. Strain relief and shielding against external influences is achieved by an M25 or M16 cable gland. Print time on an SLA printer is 4-8 hours (standing without support, on small up to 8 pieces at a time: 30-80 minutes piece time) and uses about 12 ml of resin. On FDM printers, the threads may need to be recut (consider test pieces: nut/nuts). Besides the thread should not cause any problems on FDM printers, but so far it has only been printed on SLA printers. Note: So far only the M25 version has been tested/printed on M25. Assembly: attach the smaller cable gland on one side Feed cable through the gland (on both sides) connect conductor with Wago 221-4211 push/pull bundle into sleeve (without resistance/if force is needed, something is wrong) attach second cable gland to sleeve tighten cable gland Disassembly/maintenance corresponds to reassembly in reverse order. Translated with www.DeepL.com/Translator (free version)
Statistics
Likes
8
Downloads
0