Artillery Genius Bed Cable Strain Relief - Updated/Re-aligned
Description
The previous version was mis-aligned (at least to my Artillery Genius), by about 3-4mm. I re-created it from scratch in CAD and gave it a new angle to better support the cable. The crown height was reduced such that the zip ties can properly hold it as well. Finally it was optimized for faster printing, logo removed, et al. Instructions: Raise the Z axis up out of the way, disconnect power to the printer. Remove the back-right bed leveling wheel from under the heated bed. Slide the part onto the frame and re-install the wheel. Installing this WILL raise the bed in that quadrant, you will need to re-level the bed, and be careful that the hotend does not hit the bed before it is adjusted.
Statistics
Likes
3
Downloads
0