Elegoo Mercury plus rinse tank support
Description
Support to allow the use of the Elgoo Mercury Plus system tank. This mount works with a 68mm high Nema 17 motor. Parts needed: 1 Nema 17 motor 1 GT20 pulley with a 5 mm axle 8 magnets 10mm in diameter and 2mm thick 1 system to control the engine I am using an arduino uno with a CNC shield and GRBL as firmware. As software to send the instructions I use UGS Platform, The goal is to make a gocde to turn the motor in one direction for 30 seconds then in the other direction during the same time and to repeat this cycle 4 or 5 times. It is necessary to remove the upper lip of the pulley to allow the arm which carries the magnets to come in force against the teeth. Secure the motor in place with a dab of hot glue at the corners. Update : Add tray support
Statistics
Likes
1
Downloads
0