OCTI - 3D Printing Little Helper
Description
**OCTI - My 3D printing little helper.** ** --------------------------------------------- ** Raspberry Pi Zero/Zero2 with POE hat mounting case for Ender 3 Printers. (POE = Power Over Ethernet) **Mounting base:** 2 options: centred or side mount. Depends where you want to mount this. At first i had it mounted on the base rails using side mount. Had about 1 - 2 mm gap between RPi zero case and bed wheels (photo attached for reference). After installing CR-Touch stock z-stop no longer needed so i had 2 spare sets of screws and t-nuts. Used them for this project. **Support** For mounting base and lid. Screw holes has been cut out to make screw heads flush with the print. Screws are the same which comes with Raspberry Pi standoff. Lid needs to be printed upside-down. **Housing** Fan cut out slot for 40x40x10mm RPi fan. **RPi Cam mount arm** Made to fit Ender 3 V2 cable tension cover. Camera cover : https://www.thingiverse.com/thing:3499687. Using Tinkercad i added camera lid in to mounting arm. **Disclaimer:** Not for commercial Use. Feel free to remix. Make sure you put credits.
Statistics
Likes
29
Downloads
0