BADABOOM_CATAPULT
Description
I've designed this catapult to play with my kids during xmas holidays. Since it's so much fun and easy to build I though I would share it with you ;) • Basic print settings that works fine : 0.2mm layers / 3 walls/ 15-20 % infill for big parts, 50-70 for small mechanical ones (pivots) standard PLA is strong enough (just don't put it close to a radiator/ hair dryer ;) The quantity you need to print of each part is in the name (eg: wheels_x4 means you have to print 4 wheels). • Notes : Works with any classic rubber band You might need to clean a bit some parts with a cutter before assembly. I've included a "trigger" option if you want to give it a try (I prefer the lever one) You can choose to have the lever/trigger on the right side or the left one depending if you're right handed or not. A little drop of glue here and there will make it super strong (just don't glue the arm obviously). I recommend to make a trial fit before you glue anything though. Hope you and your kids will like it! If so, likes/shares/feedback and tips are much appreciated ;) Enjoy, Alex
Statistics
Likes
2
Downloads
0