Creality CR-6 SE Filament Run-out sensor Housing Riser Sapcer
Description
It's not really a remix. I upgraded my CR6-SE extruder to a cheap dual-gear one from Amazon as the bog-standard plastic one was awful and I had no idea if if was filling up with rubbish or not and it was impossible to adjust! Unfortunately, that meant the filament sensor was 10mm too low. I just traced the bottom of this one and increased the bolt-hole diameter slightly. Works brilliantly. Much more stable than the two 10mm M3 spacers I was using before! Checkout my make for more and better photos. I've used the version with fillets on the bolt-holes, but not on the outside. Feel free to remix this for other extruders - although you can always just scale the height in your slicer! I've included the Solidworks files, but you can always import the STL of the one with no fillets into any software if you want to modify it.
Statistics
Likes
4
Downloads
0