DJ Booth Music Box
Description
#DJ BOOTH MUSIC BOX This is a housing for the YunSheng 18 Note wind-up music box mechanism (https://www.amazon.com/Yunsheng-Clockwork-Mechanism-Movement-Replace/dp/B07CZK3F6Y) to make it look like a DJ booth. The record will spin as the music plays; with other movable parts including the knob (rotates), pitch control (up & down), and needle (swivel). *Note: I have included all parts as 3D-printable models. However, I recommend using a snipped off piece of paper clip for the needle arm, and a thin bent metal sheet for the pitch control. I printed the gasket using Varioshore, but any flexible filament should work (alternatively, just cut out a bit of foam)* Hope you enjoy making this! Shoot me any questions in the comments section or via direct messages if you have any questions.
Statistics
Likes
5
Downloads
0