VanMoof Pannier Rack AirTag Holder
Description
This is a 3D Printed case designed to hold an [Apple Airtag](https://apple.com/airtag) on the official pannier rack on my [Vanmoof](https://vanmoof.com) Electrified S2 bike. The S2 does not have an airtag pre-installed, and the vanmoof GPS tracking is unuseable after a maximum of 3 years ownership, and is not renewable?! The S2 pannier looks like it probably has the same dimensions as their current [Rear Carrier for S3](https://www.vanmoof.com/shop/en_gb/accessories/s3-rear-carrier) product. ### Design Consideration I designed it just to be superglued together, so it can't be easily removed. With it placed in the middle between the two side bars, I can still fit my ortleib pannier bag on without the clips interfering with the airtag mount. ### Assembly I printed it in PLA. I first glued the Top and Bottom parts around the rack, and cable-tied it on while drying. Once dry, I inserted an airtag in the hole, and superglued the lid on, with dots on each corner, and cabletied it on to hold it while drying. Afterwards I poured a small line of superglue along each seam of the lid, to ensure it was closed.
Statistics
Likes
0
Downloads
0