ISpec EV to 22.2mm Bar Clamp
Description
22.2mm bar clamp to mount an I-Spec EV shifter or dropper lever. Uses: * 1x M4x15mm bolt + M4 nut * 1x M5x12mm bolt + washer Print with 4+ wall thickness and 100% infill. You may find it difficult to get the M4 nut into the recess if your printer calibration is a little off - would recommend -0.1mm expansion if this is the case. M5 threads have been modeled into the mount to attach the shifter, but I would recommend chasing them with an M5 tap using some lubricant. Due to the small wall thickness on the top and bottom (and tolerances with FDM), driving the M5 bolt into the plastic threads without chasing will likely split the plastic.
Statistics
Likes
0
Downloads
0