Sonoff Basic R2 Power v1.0 Programming Jig
Description
I've tried a lot of different programmers, and none seemed to fit quite right, or hold in place easily on my Sonoff R2 Power v.10, so I decided to make this one. Simple print, no supports needed (though mine the board holder seems to pop at the corners.) I used 1mm pop pins, and stuck 2.54mm jumpers on to them (the jumpers are a little small, but they work.) When you're programming, It would be a good idea to add a switch to the 3.3v line so you can power the board off and on easily (you have to power it off, press the button next to the LED (careful, it breaks easy if you shift it to the side), and keep it held for 5 seconds after you power it back on. Set your FT232 card to 3.3volts, and connect TX, RX, 3.3V and GND (TX and RX might need to be switched) ...If you program it with EasyESP, the password you're looking for is "configesp" (no quotes) https://www.amazon.com/gp/product/B09CKMZ5YY/ref=ppx_yo_dt_b_asin_title_o07_s00?ie=UTF8&psc=1 (These aren't the ones I used, I got mine a long time ago from who knows where) https://www.amazon.com/EDGELEC-Breadboard-1pin-1pin-Connector-Multicolored/dp/B07GD312VG/ref=sr_1_6?crid=Y1HMHBZ6BQW5&keywords=2.54+mm+wire+connector&qid=1640375155&sprefix=2.54+mm+wire+connector%2Caps%2C89&sr=8-6
Statistics
Likes
0
Downloads
0