Marvel Legends Iron Man (Punisher) Helmet Motorization Kit
Description
***Available for purchase is an easy to install and use Arduino shield (Nano included) designed specifically for this project. This Board comes pre-flashed with the Crashworks code installed.*** A.L.I.S.H.A.(MK2, MK6, and MK7), S.U.E. (Sound Unit Expansion), PENELOPE (USB Power Keep Alive Board) ***https://www.ebay.com/itm/403228425344*** ------------------------------------------------------------------------------------------------------------------------ *** Link to our MK7 Helmet motorization kit: https://www.thingiverse.com/thing:4630066*** *** Link to our MK46 Helmet motorization kit: https://www.thingiverse.com/thing:4640029*** *** Link to our MK85 Helmet motorization kit: https://www.thingiverse.com/thing:4607836*** ------------------------------------------------------------------------------------------------------------------------ ***This is a complete motorization kit for the Marvel Legends Iron Man helmets *** ***Use this link to download the required Arduino code for this project: https://github.com/crashworks3d/Iron_Man_Servo*** *** As the Arduino code is constantly evolving, if your code exhibits any unusual behavior please check the GitHub link to ensure you have the most current version of the Iron_Man_Servo Code *** *** Please read attached Marvel Legends Iron Man PDF Document, it lists all the steps necessary for this project*** ***You will need metric size screws for this project, the most common sizes are M3 & M4. As an example they are normally labeled as follow M3-0.5 which means M3 (Diameter / Size) -0.5(Thread Pitch), or M4-0.7 which means M4 (Diameter / Size) -0.7(Thread Pitch).*** Included are all of the files needed to fit and align servos into your helmet. Servo mounts for both the Tower Pro MG90s and clone Non-Tower Pro MG90s servos are included. Included files: ***Marvel Legends Iron Man PDF*** Legends Servo Mount (Tower Pro MG90) Legends Servo Mount (Clone-Tower Pro MG90) Servo Horn Arm Geared (45mm) Faceplate Bracket Rounded (MK7 74.5mm) Helper Arm Slider 46mm (M4) Helper Arm Standard 46mm (M4) Helper Arm Mount Tall (M4) Wire Cover (Servo Mount) *** Do not scale any of the files, as they are all size specific *** ***Print the following files:*** 1x Tower Pro servo mount -OR- 1x Clone Tower Pro servo mount 2x Servo Horn Arm Geared (45mm) 1x FacePlate Bracket Rounded (74.5mm) 2x Helper arm slider 46mm (M4) -OR- 2x Helper Arm Standard 46mm (M4) 4x Helper Arm Mount Tall (M4)
Statistics
Likes
33
Downloads
0