Overton in G-Gauge 45mm
Description
This is an upscale and print readying G-Gauge version of Depronized's Overton coach, with 3 extra coaches added on All coach sides etc are in halves, and designed to print flat. Roof is in three sections Axles now use 4mm rod 58mm long Bearings are 4 x 8 x 3 Most parts are just "upsized" but bogie sides and bogie frame needed quite a bit of tinkering to get a gauge correct. A 40mm block for back to back wheel distance is also included Interiors are in a separate thing, at https://www.thingiverse.com/thing:5176504 Found out that when joining half sides, its a good idea to have a brace along the back at the top and the bottom. Have added some braces, but not sure if they are the right size. Will fix later, if I find they are too wide. 29 Dec 21, Added side box and stays 30 Dec 21, Replaced wheel with one with 4mm axle hole to match bearings 2 Jan 22, Since base needs to be joined, decided to incorporate under chassis boxes with a stiffener. Also modified bogie frame (Alt version) to hopefully (untested yet) accept knuckle couplers found at https://www.thingiverse.com/thing:1908821
Statistics
Likes
3
Downloads
0