Satsana Creality Laser Attachment Simple Scottyujan *REMIX*
Description
Hello! This is a remix of the Satsana remix from Scottyujan. This is a part you attach to your fan once you remove the fan grill. You can then add a laser! I made this so I can easily swap the fan grill out with the laser for easy and simple quick use. How to install ------------------- Once the part is printed you just need around a 3mm drill bit. Then drill through the flat bit on the part so you can use a 3mm Bolt to attach the laser to the top screw hole in the laser. I found that only one screw at the top is needed to secure the laser. As seen in the pictures connected to the big blower fan I also attached XT30s (Would recommend smaller connectors XT30s are overkill) so It is easy to unplug the fan to plug in the laser. Pictures are shown above of wiring Things you will need --------------------------- 1x Printed Part 1x hex bolt (3x6)mm 1x around a 3mm Drill bit How to Print ----------------- I would recommend higher infill with PETG Please use the image above on how to position it.
Statistics
Likes
2
Downloads
0