Tray for Anycubic 4Max Pro 2.0
Description
This is a tray for the inside of a 4Max Pro 2.0. I stick it on the left side and throw failed prints into it because I'm lazy. Basically, it's a graveyard. The width is short enough so that the bed shouldn't bump into it if it goes down that far. Bevelled inside corners so that it's easier to get smaller pieces out. Made fresh but inspired by this design here for the 4Max 1 https://www.thingiverse.com/thing:3946088/files Made in Blender.
Statistics
Likes
1
Downloads
0