Collector's Dice Box - Kraken 12pc Set
Description
This is a two piece box designed to hold a 12pc Kraken Dice set. While the two halves come together, they do not friction fit and will need a total of four 8x3mm magnets to keep the lid shut. The grooved magnet spots should keep the box from sliding apart. The magnet wells should be just big enough to fit the magnet and glue it in place. The Bottom.stl has 11 wells, with the middle well holding both the D4 and D2. The bigger hex on the side is for the D12. The rest of the dice should fit loose, but not rattle too bad. The Top.stl has hexagon posts that help prevent the dice from rattling too much while inside. The thickness of the top and bottom layer is 1mm, allowing you to use a clear or transparent filament for the first layers. This will let you see the dice without opening the case, but be thick enough to be sturdy. Extra parts needed for this project are: 4x - 8x3mm Magnets (Two for each piece) I printed this with a .6mm Nozzle, at 30% infil. No supports. **About the design -** This "Hex" design is inspired by another dice box I had come across, but that box was too small for my purpose and used more filament than I would like (I have about 40 of these to make!). I built this one from the ground up to be a bit larger, lighter weight, and see through with clear filament for the first layers. In its current state it is printable and practical, but can use some extra care in aesthetic and design features. I have not drop tested this model.
Statistics
Likes
2
Downloads
0