Another Dillon Primer Pickup Tube Holder
Description
Like the world needs another primer pickup tube holder, but here it is, nonetheless. I got tired of my eBay-purchased holder which attempted to snap in the primer tubes and did a terrible job of it. This is a lift-out design, similar to a few others I've seen here. It's designed to fit onto the Dillon casefeeder bowl. The prongs are long enough that you don't have to orient the plastic tab on the tube in any particular direction. Other than that, I tried to keep it reasonably low profile. The holes in the back are tap drill for a 6-32 thread. If you don't have a tap handy, you can drill it out to .120 and thread a screw in without tapping. If I do another version of this, it will probably be a friction fit to eliminate the screws - just not sure I want to spend any more time on it
Statistics
Likes
0
Downloads
0