cigarette/joint tube (Vase Mode)
Description
A tube for a "cigarette" to print in Vase-Mode. A brim is recommended, due to its height. You should use a 0.4mm Nozzle with 0.45mm to 0.50mm extrusion width, depending on how precise you are able to print the thread. I don't really remember which one it was, I designed this 6 months ago. 0.45mm should work just fine. The bottom of the lid should be around 1mm thick to fit perfectly. The tube fits cylindrical shaped cigarettes, not cone shaped ones. Fits active charcoal filters too. I uploaded a 90mm long version, and a 110mm for long papers.
Statistics
Likes
0
Downloads
0