VOXELAB Tool Box Middle Extrusion
Description
Flip it 90 degrees so its standing up. No supports or brim/raft necessary. edit: I added a screw so the drawer doesn't fall out. I heated up a hex key and held it with a magnet, and pushed slowly through the plastic in the corner as to not be in the way of anything when closing. see picture, blue bracket. as for the inside part, called cajon.stl, I printed that laying down, and had it about -1.9 in the Z below the plate so it prints evenly on the bottom, dont worry about the bottom of that tab being cut off. this is so no supports are needed. I took the Toolbox which is also meant for the Ender, this happens to say Voxelab on it. I added 2020/4040 extrusion mounts so that it will be able to mount at the Y plate carriage extrusion.check pictures.
Statistics
Likes
5
Downloads
0