DIY 3:1 Gearbox Nema 17 Smoother Prints "Vertical Fine Artifacts"
Description
It is all explained in the following Videos. It is ment to reduce "Vertical Fine Artifacts" due to resonanz while printing. English: see video https://youtu.be/0B9KExVG15I Deutsch: Siehe Video https://youtu.be/aWewZ54gcsk Just print two of these STL Plates to connect your Nema 17 stepper motors. The two plate versions are slightly different in case your stepper motors are a bit different in housing length. So you have more or less play. Additional Material needed: - spare nema 17 stepper housing lenght 40 mm - shaft 5mm and 90mm lenght - two adjusting rings 5mm to keep the bearings within the housing when removing the inner rotor from the spare stepper - belt GT2 172 teeth - pulleys GT2 20 and 60 teeth - a few M3 bolts to get it together
Statistics
Likes
7
Downloads
0