ANYCUBIC Photon Mono X Clip On Heater Mount
Description
ANYCUBIC Photon Mono X Clip On Heater Mount This is a toolless clip on heater mount with (or without) a temp probe mount Prints with NO SUPPORTS! Here is the heater used: https://www.amazon.com/gp/product/B07573FKSG/ The zip ties are 2.5mm MAKE SURE YOUR WIRES ARE AS FLAT AS POSSIBLE AND AS CLOSE TO THE MOUNT AS POSSIBLE (there's zero space back there) Probe hole is 5mm so should fit most probes Here is the dual probe thermostat I use: https://www.amazon.com/gp/product/B083Q7YRBM (one probe inside the printer enclosure itself, another for my tent) Another more popular single outlet probe: https://www.amazon.com/gp/product/B01I15S6OM Note: maybe "clip on" wasnt the best name as although you probably can clip it on, I always slid it on from the top by taking the top plate off... Print the bottom spacer upside down Note: I recommend printing this first to make sure your printer is dialed in and it fits I used PETG because I seen PLA wasnt good to use inside the printer's enclosure? Not sure though Here are my print settings: Printer: Ender 3 0.4 nozzle 0.32 layer height 0.45 line width 3 walls 4 top/bottom 10% cubic infill 245/80 temps Lastly, if you end up making it, please take a picture and post a "Make" something about seeing other people print something I designed always blows my mind.
Statistics
Likes
4
Downloads
0