Prusa i3 rework frame stabilizer
Description
Parts Needed: -You Will Need To Replace The Rear Y Axis Threaded Rods (At Least 370Mm, Same With The Frame Width). -2 Threaded Rods (About 400Mm Each) To Connect The Bottom And The Upper Parts. -16 M10 Nuts And Washers -Optionally You Could Drill One More M3 Hole On The Frame For The Upper Part (20Mm Below And Between The Other Two Holes). -You May Need To Replace The M3 Screws If They Are Two Short. Note: The Distance Between The Frame And The Rear Threaded Rod Is 100Mm. Inspired From Thing:430732
Statistics
Likes
31
Downloads
0