Pegboard Digital Micrometer Hook
Description
A pegboard hanger for digital micrometers. I think that all theses have close to the same dimensions so it should work well for you. I've pictured it holding my Neiko and a cheapie from amazon. Both hang straight. The hooks have about 33mm of space inbetween and the hooks are offset vertically by 15mm. The holes for the hooks were a little loose in the one I printed and I did have to glue them in. I tightened up the hole tolerance and it should be better. Worst case, they're a little too tight and you may have to file just a little. No supports are needed but you must rotate the base to lay flat. Also, I found that upping the wall count to 3 makes the hooks stronger but I'm sure that standard 0.2mm settings will work. Print the base STL and 2 of the hook STL. I used a small (4mm) brim but I always do to prevent corners from pulling off of the print bed.
Statistics
Likes
0
Downloads
0