Directdrive cable chain mount with EZABL bracket
Description
I created this due to a problem that I encountered after mounting all of the parts, specifically the X-axis cover that connects the opposite end of the cable chain that this design is used in. Because my EZABL probe was mounted on the left side, it collided before the x-axis switch was hit. Also of note my V6/BMG combo is mounted with the Printermods MDD backplate. So, I decided to move it front and center utilizing the part already on hand. I created insets for M3 nuts, and used M3-8 screws to mount it. I neglected to make the insets slightly larger than the physical nuts, should have upped them by .2mm. Therefore I just heated up the nuts a bit with a butane torch and they went in no problem.
Statistics
Likes
1
Downloads
0