Wireless Cell Phone and Watch Charger Stand, Anker and Galaxy Watch 4
Description
Created a stand for my Anker wireless charger and Galaxy Watch 4. Uploaded the fusion files so you can go through and resize the hole sizes if needed. I created some channels for the cables, found that I have a thick USB cable that didn't fit the channel but it fits most of my other ones. If it's a little to loose to friction fit the pucks in the holes, a small strip of duct tape around the outside edge can give it the perfect fit. Also, found my version one was a little tippy so added an extension arm on the back to give it more surface area with minimal extra filament. (V2 Files, or in fusion file, the last couple steps) Prints without supports but for really clean lines a tree support for the top of the main charger circle makes it nice.
Statistics
Likes
0
Downloads
0