Anycubic Mono X Lid Spacer for Heater Wires
Description
Anycubic Mono X Lid Spacer for Heater Wires Please note: evidently there are two different lids? I'm not sure if thats accurate or not but my machine was purchased Novemeber 2021 if that helps anyone? I made this to go with the <a href="http://www.thingiverse.com/thing:5181931>ANYCUBIC Photon Mono X Clip On Heater Mount </a>to feed the wires out. There are other designs however I didnt like the overall feel, I wanted something sturdy. This screws in using the 4 stock holes however the stock screws are too short once added so you'll replace them with four M4x15mm Hex screws. The 4 corners where the screw mounts are 2mm off the build plate so you'll need to have your support and everything dialed in perfectly. <b>I've included a support test file<b/> as well as my print settings for reference The file itself is 290mm x 270mm so you'll need a larger print bed, and no I'm not going to break this into pieces as I feel like that would make the already noxious fume situation worse <b>Note: With the current "Work in Progress" (beta) design you will loose the safety sensor for the door/hood/canopy. By downloading User assumes all risk and responsibility. By downloading User also acknowledges and understands the above and agrees to hold the creator harmless from any and all liability</b> I printed in PETG and here are my settings: Machine: Ender Extender 400x400x500 Nozzle: 0.6 Layer height: 0.48 Line Width: 0.6 Walls: 4 Top/Bottom layers: 5 Infill: Cubic @ 20% Temp 245/80 Cooling 60% Speed - SLOW only 20mm/s Support 70 degree overhang, zig-zag, 0.48 z distance, .06 x/y distance, <b>Enable Support Interface</b>, Support interface thickness 1.92, interface density @ 70%, Pattern Grid Bridge Settings ENABLED <b>Here are my other designs for the Anycubic Mono X 4K</b> ANYCUBIC Photon Mono X Clip On Heater Mount http://www.thingiverse.com/thing:5181931 ANYCUBIC Photon Mono X Z-Axis Bumper Guard http://www.thingiverse.com/thing:5185340 If you do end up using any of these, please take a picture and post a "make"
Statistics
Likes
5
Downloads
0