Wanhao D6 / Monoprice Maker Ultimate easy print push buttons
Description
I lost the diminutive screw for my Wanhao Duplicator 6 control push button, so it started to fall off most of the time. I tried to find a ready alternative but the only one I found was quite complex to print so I created my own easy to print versions in FreeCAD. Version 1 is a direct replacement for the original with additional depressions on the side for easier grip. If you print it in translucent PETG, light from inside the machine will shine through. Version 4 is a gear for an even easier grip albeit slightly smaller than the original button. There is no need for a screw as it should be a tight fit, sufficient to keep the button in place.
Statistics
Likes
0
Downloads
0