CR-10s Pro Fanduct Dual Outlet - Print in Place
Description
Remix made to eliminate some issues I found with the original design. Printed in PLA, Tested and works flawlessly. Recommend to print this in default orientation (bottom side touching the buildplate(!)) to prevent a drooping model once attached. Modifications made from original: - Changed Mount section where the fan is attached, you now need to remove the front cover of the fan (super easy), but this provides a sturdier fit. Original slid over the cover, but proved too brittle And required to swap the screws used. This in turn also removes a small gap between the fan and the fan duct. - Screwholes now have added structure to make sure no support is needed during print. - Since the mount is now changed you WON'T need to change screws from the stock. - Small tilt was added to the mount section to remove potential air gaps and to make sure the fan ducts don't drop too close to the bed. - Brace was added on both fan ducts to reduce the possibility of warping during operation. - Protective grill added in front of the fan opening to prevent objects from touching the fan (..and who doesn't love hexagons ;) )
Statistics
Likes
0
Downloads
0