Mudkip
Description
ABOUT: This is an Altered model of my own of the following: (not printable) Mudkip (Read Description). This model can be found here: https://www.thingiverse.com/thing:4618841 https://www.prusaprinters.org/prints/112445-not-printable-mudkip-read-description This new model is printable! With a few modifications, I solved the bed adhesion issue I had by giving the model more surface area attached to the bed. In addition, I split the model into two. this allows for the body to be printed with more infill, solving the top-heavy issue I had. I also added my "XIAO" mark to the back of the body. PRINTING: supports are needed I suggest printing at .2mm of finer for both pieces. The head is good at 15% infill, with the body being 30% POST PRINT: As long as you print at 100% scale or more, the pieces should just lay together. You can glue them if you desire.
Statistics
Likes
0
Downloads
0