CR10 Hotend / X-Carriage Adapter for Prusa i3
Description
Customized Prusa i3 X carriage to support the BigTreeTech / Biqu hotend with the Creality CR10 bolt pattern. It can be used with several other Creality hotends, but most of them won't fit in the adapter piece, so you'd need to make your own standoff from the carriage plate. Features a cable chain mount at the top of the X carriage. Includes linkage adapters that can be hot-glued to the top of the X-end motor assembly, as well as an MK2 motor mount piece with a receiver linkage (if your X-end motor is on the other side like a normal person, just mirror it before you print). Because this significantly improves clearance, some Z endstops might not be able to get low enough to clear the motor coupler, so I included my endstop bracket. Requires 45mm long M3 screws to get through the full assembly. Remove the hat from the top of the hotend to slide the adapter over the heatsink, until the mounting holes line up. The fan mounts to the ends of those threads on the back, you can just screw them directly into the fan adapter. Included a second X-carriage version that doesn't require zip ties on the bearings, but I haven't tested it.
Statistics
Likes
0
Downloads
0