Nintendo Switch Joycon Rifle / Gun / shotgun
Description
This one is very rough and I had a few issues creating some parts of the model but if you follow the instructions it should print fine for you. I printed this on an Ender 3 v2 with the following Cura Settings: Draft Quality (0.32mm) Infill 10% supports (touching plate) 20% All three parts can fit onto the bed at once and took around 12 hours to print. I would print it with the 'controller catches' at the top, see my Cura picture for an example (rotate part 3 upside down / 180 degrees - sorry i didn't want to mess with it as it printed fine). Also Part 3 has a small issue and has an extra bit of material on that side which I could not remove for some reason (walls started to disappear). This means if you then try and print it there's a gap between it and the bed. To resolve this problem set the part to be -0.3mm on the Z axis (for that part only), so it's just under the bed and it will print fine. Also because of the wall disappearing problem I got sick so the model does not clip together. All you need is a bit super glue to join the three parts together :) I don't own any copyright, etc for Nintendo I am just a fan
Statistics
Likes
0
Downloads
0