AMMO BOX - .38 SPL / .357 Mag - 50 ROUNDS
Description
First attempt at a ammo box for .38 Special / .375 Magnum cartridges to hold 50 rounds. I tried designing the box to be printed without supports, but as I have not printed it yet, I'm not quite sure of all the tolerances and how well it will fit together. Feedback on the design would be greatly appreciated, let me know if the sizing and tolerances are ok or if any adjustments are required...Does anything need to be strengthened? For the hinge, I plan on using a piece of 1.75mm pla filament as a hinge pin and heating the ends to secure in place, as I have seen done on other similar box designs.
Statistics
Likes
0
Downloads
0