Metroid Stand
Description
Printed at 1.3 scale 1 layer height 25mm/s print speed 10% infill Supports everywhere Support infil 10% Support type lines support angle 30 degrees Leave the metroid upside down for best quality. This is a remix however I cannot find the op content, I downloaded the metroid model a while ago. If you have the link or find it, please comment below so I can update the description. I wanted to print this for the inside of my pc. Tried print the metroid and stand together but the supports would get stuck in the model or there would be layer drooping. With the threaded model and above print settings, there was no dropping and minimal cleanup. Printing a v2 at 1.8 scale now and will post a picture of it when finished.
Statistics
Likes
0
Downloads
0