Zelda - Master Sword - for belt printer like INFI-20 CR30
Description
This remix was created for belt printers with 'infinite Z'. The central hilt, handle, and blade are one long piece. Since the X axis is limited, I separated the cross guard 'wings' and added registration marks to the pieces. To have flat surfaces to print from, everything is then cut in half horizontally. You will want to print 6 pieces total: Top - Right, Center, Left Bottom - Right, Center, Left Then I Gorilla glue gel the top and bottom parts together. Pieces are named so when you're looking at that side, left is left and right is right. So you will be gluing "Top Left Wing" to the "Bottom Right Wing". Although, this probably doesn't really matter much, the pieces are similar. The first two things I did to my INFI-20 were to season the belt with some Aquanet hairspray, and replace the nozzle with a 0.8,mm. I suggest you do the same. Even with a 0.8mm nozzle and 0.4mm layer height, it takes nearly 12 hours to print. Side note, this model works well with belt printers' 45 degree angle with no support.
Statistics
Likes
0
Downloads
0