Ender3 V2 Push on Squash ball feet
Description
I made these to slide over the existing rubber feet on the Ender3 V2. It cuts down vibration and noise a lot. You need 3 x squashballfoot and 1 x squashballfoot with PSU cutout for the rear left foot. The squashballfoot will print without support, the PSU cut-out requires it The difference in the noise reduction is insane, if you have your Ender3 V2 on a desk, you need to get these printed and installed. I used 4 x Unsquashable 2 yellow dot squash balls, But im sure any others would work just great.
Statistics
Likes
0
Downloads
0