DIY guitar under 60€ with 3D printed parts.
Description
In this video I build an electric guitar with 3D printed parts. The construction costs amount to about 50 €. The most interesting thing is certainly the pickup. This was built from 15x5mm magnets. About 8000 windings were wound up with a 0.05mm copper wire. I bought a cheap amplifier on Amazon and connected to the pickup. At the beginning of this project, I just wanted to build the pickup. But since this worked so well I built a whole guitar. The result is a cheap electric guitar that works well. A very instructive project where you can easily recognize how to convert sounds into an electrical signal. Here you can see the Video on Youtube: https://www.youtube.com/watch?v=AYcQbBpXgf8&list=PL9Jzxu1vDldPy2bK8hG3s78jLnHpclBQm&index=1
Statistics
Likes
0
Downloads
0