FGC9 printable suppressor mount
Description
this mount is compatible with fgcmk2 download compatible supressors here https://ctrlpew.com/k-cad-suppressor-pack/ https://www.defcad.com/library/2f0cf953-8863-4bef-ac5d-b05bb66f8560/ https://odysee.com/@TheGatalog-Suppressors:a/K-CAD-3D-Printed-Suppressor-Pack-V1.0:d in guide from JStark there are 2 ways of mounting suppressor to fgc9 by buying adapter from aliexpres which can get knocked off a gun easily or buy a lathe and tap your barrel but i think there is a better way of mounting suppressor without lathe and fragile garbage from aliexpres just print the damn thing so here it is, 3D printed suppressor mount its designed to be used with K-CAD 3D Printed Suppressor Pack only D size and bigger you will need same tread inserts as for fgc9 (generic M3 tread inserts) “M3 X D5.0 X L7.0 20 of them 12 screws M3, 10mm long DIN933 M3x10 4 M3 screws, 15mm long DIN933 M3x15 printing use PLA or something more thermal resistant infill: 100% supports: yes instalation: put the suppressor mounton barrel (flat side facing barrel end) if its too tight heat the barrel up with soldering iron and melt it on the barrel melt in tread inserts to sides deep as possible and put screws (short M3 screws) in tighten them just enough so they touch the barrel after that go after small steps one by one dont tighten one screw hard af before tightening sescond one you need to make this thing straight or it will not work very good melt in 4 tread inserts from top of the mount choose from suppressor pack mount of D size or bigger on and secure it with duct tape after this line i will reffer to a mount from k-cad file as an Tmount to prevent confusion try to make it perfect, any errors will result in inacuarcy grab soldering iron and push inserts into mount deep enough so they will touch Tmount and leave a mark use this mark to drill a 4mm hole (or 5mm, its up to you) melt inserts into suppressor body try to screw it in place with longer 15mm M3 screws if it does not fit readjust position of tread inserts in Tmount to match inserts in suppressor mount if you have done everything go ahead and make rest of the suppressor by using guide from K-CAD pack
Statistics
Likes
1
Downloads
0