4s 26650 Battery Holder
Description
Its a 4-cell 26650 battery pack. The battery pack can be used to supply 12V DC, or charge a dead vehicle battery enough to start. LiFe chemistry batteries are the best choice for this application. Will work with soldered tabs or glue in contacts for the batteries. The cap is a tight fit so that it can be glue on. The hole through the middle will fit a 1/4" or 6mm bolt to allow it to be bolted to something. The battery pack has a passthrough for two 5mm wires and the balance charge connector. I borrowed the aesthetics from this design. - https://www.thingiverse.com/thing:2128354 I redesigned the battery pack to make it a little easier to FDM print and made it a little stronger. If using a 0.4mm line width the battery pack should print as walls and not need to fill gaps.
Statistics
Likes
0
Downloads
0