Snapmaker 2 Glass Bed Mounting Bracket (snap-on)
Description
Updated the original design with two improvements: (1) No hardware or tools needed, just snaps tightly onto the underside of the platform (2) Added support for the new square-framed platform The advantage of this mounting bracket is that it doesn't cut into your usable print area at all and will not get hit by the proximity probe during printing or calibration. All other brackets I have tried, as well as tape or binder clips, would get in the way somewhere because they overlap the glass. Or print area was lost due to significantly smaller glass plate with brackets on top of the heated bed. Additionally, since the glass just sits inside these corner pieces, it is easy to remove the glass quickly to switch back to the magnetic sheet or use with a quick change laser bed. Or you can put the magnetic sheet on top of the glass for auto leveling if you choose. This is designed for glass that is exactly the same size as the heated bed. Adjust the side walls if your glass is larger than your bed. My own is a tiny bit smaller than the bed, so I use a little bit of foam tape to keep it snug. Print four corners total -- two normal and two mirrored horizontally. Only tested on the A350.
Statistics
Likes
0
Downloads
0