4X6 Frame for Refrigerator
Description
A simple frame designed to hold a 4" x 6" image. My original intention is to use this for recipes. The print surfaces are indicated in the drawing and you should be fine with no supports if printing with PLA. Magnet size is also shown in the drawing. The fit is very tight and should need no adhesives. I was able to install the magnets by push against a hard surface; you may need to run a blade around the holes anyway. The frame holds prints quite loosely until placed on a magnetic surface- this is intentional to make change outs easy. https://www.kjmagnetics.com/proddetail.asp?prod=D51-N52
Statistics
Likes
0
Downloads
0