RSM 3 Tyre Truer Reciprocator
Description
This is another remix but this one is for the RSM3 Slot car tyre truer. This remix uses Slot car round magnets we normally stick together and never use, the 8mm diameter ones push into the 'magnet joint' and 'magnet short arm'. The RSM 3 truer should be a snug fir into the 'RSM base unit' and can be secure in place with two 'roller' discs but may not be necessary if the truer is snug enough. The 'gantry' is a snug fit over the 'RSM base unit', again two 'roller' discs can be held down with screws but again may not be necessary if the fit is snug enough. The 'motor arm' slides onto the shaft of the reciprocator motor. The motor I used is a 'Geared Micro Motor Speed Reduction Gearbox - 12V ⋅ 30 RPM' I soldered wires from the reciprocator motor to the truer motor and run it at 4v
Statistics
Likes
0
Downloads
0