Ender 3 (Pro) IKEA Lack setup
Description
This is my IKEA Lack setup for an Ender 3 Pro with a SilverCrest SDA 350 food dehydrator as filament dryer. Print settings and material selection is up to your experience, but you can see my recommendation below. BOM: - Silvercrest_Dehydrator_SidePiece-1.obj - ABS - 3pcs - Silvercrest_Dehydrator_SidePiece-2.obj - ABS - 1pc - Silvercrest_Dehydrator_CenterPiece.obj - ABS - 1pc - TPU_feet.obj - TPU - 4pc - ElectronicsCase_motherboard_lid.obj - PLA - 1pc - ElectronicsCase_motherboard.obj - PLA - 1pc - ElectronicsCase_Raspberry.obj - PLA - 1pc - ElectronicsCase_Raspberry_lid.obj - PLA - 1pc - MeanWell_LRS-350-24_8020_lid.obj - PLA - 1pc - MeanWell_LRS-350-24_bracket.obj - PLA - 2pcs - IKEA_Lack_stack_mount.obj - PLA - 4pcs - IKEA_Lack_riser_50mm.obj - PLA - 8pcs - IKEA_Lack_filament_guide.obj - PLA - 1pc - PSU_Plug_socket.obj - PLA - 1pc - Cable_through_hole.obj - PLA - 1pc - 16mm_pipe_mount.obj - PETG - 2-4pcs - Fan_inlet_pipe.obj - PLA - 2pcs - Fan_inlet_intake.obj - PLA - 2pcs - Door_handle.obj - PLA - 1pc - Door_handle_magnet_mount.obj - PLA - 1pc - Door_handle_counterpart.obj - PLA - 1pc - LED_stripe_corner_mount.obj - PLA - 4pcs
Statistics
Likes
0
Downloads
0